Package includes:

1x PDB 

Please note the board's layout/solder pads may differ from the picture.

Specifications:

Weight: 7.8g
Input Voltage: 2-6S
In theory, this PDB can handle 100-120A current.
BEC Output: 5V & 12V (3A Current)
You need to use 4S battery if you need 12V BEC to work properly. It does not make sense to use a 12V BEC if you only use a 2-3 Battery.
Installation Screw Hole: M3*30.50*30.50 (30.50mm distance between the center of two M3 holes)
Was designed for CC3D/Naze Flight Controller

 Remark #1: By default, the 12V BEC will be used and LC Filtered which is suitable for 3-6S Li-Po battery input. But if you use 2S Li-Po (in this case, the voltage is lower than 12V), you can clean the default soldered iron on "12V" and solder "BAT" side instead. This will skip the 12V BEC so that all 12V BEC Output Voltage will be directly supplied by Li-Po Battery Input.

Remark #2: You need to solder the pads by yourself to decide whether to use 5V or 12V BEC. Please be careful when soldering the iron, only apply a little iron on the pads because the pads are really small. We are not responsible if you fail to make it right.